Perun V2 Hybrid replaces classic mechanical contacts in airsoft guns and provides a number of useful functions. Optical and magnetic sensors eliminate moving parts that are prone to damage, increasing reliability. Adaptive trigger control enables switching from a short trigger stroke to a long one even directly in the field.

Installation is with most V2 gearboxes (in the Tokyo Marui standard) without the need for any modifications. See the manual for details and exceptions.

FUNCTIONS

Trigger sensitivity - trigger sensitivity can be set in 5 sensitivity levels, from very short to very long. No adjustment of the trigger or gearbox is necessary. Changing the sensitivity of the trigger is also possible in the field. Independent programming of the fire switch - program the fire modes however you want, by setting safe / semi / auto in both switch positions.
Active brake - allows the motor to stop after each shot. For the double shot problem in high cadence weapons, an active brake is an effective solution. It can also prevent unnecessary compression of the spring - the piston will remain in the forward position between shots. You can turn the active brake off or on in seconds.
Piston preload - quick trigger response can be the difference between winning and losing, especially in CQB. With the piston preload activated, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot will take place immediately after the trigger is pulled. To release the spring after applying preload, press the trigger and hold it for 2 seconds, then a second shot will be fired, this time without preload.
2-position trigger - a light press of the trigger fires the weapon semi (or burst), a full press burst (or auto). Available modes: semi - burst, semi - auto and burst - auto.
Double shot mode - allows you to set two shots in semi-automatic mode. After turning on this scheme, the weapon will fire not only when the trigger is pressed, but also when it is released.
Cadence reduction - reduces the cadence in auto or burst mode for more realistic weapon behavior and reduced ammunition consumption.
DMR mode - ensures intervals between semi-automatic shots to comply with DMR rules on some courses.
Battery protection - the battery protection mode is intended for Li-Po and Li-Ion batteries. If the battery voltage drops below a critical level, the user is warned by short sound signals repeated every minute (the warning can be turned off). DSG - piston gear detection mode specially designed for double piston wheels.
Diagnostics - the processor constantly monitors the state of the weapon and the mosfet itself. In case of any problems, it will immediately notify you of the malfunction, which will greatly facilitate troubleshooting.
Electronic fuse - saves your gun and battery in the event of a serious malfunction. It automatically disconnects the battery when it detects a short circuit or a blocked motor.
Programming of all settings is done exclusively using quick and easy-to-remember firing switch and trigger pull sequences. The current status is confirmed by sound signals and a multi-colored LED. This allows the setting to be changed at any time, within seconds, even under enemy fire. All settings are set separately for each position of the firing switch, so you can program the mosfet exactly as you want - for example semi to semi and binary trigger to auto.

The Perun V2 Hybrid works without problems with any battery from 7 to 17 V, the wiring is powered by a Dean-T connector.

The Perun V2 Hybrid was tested by the manufacturer in the gearbox of the following manufacturers:

A&K, Bolt, Classic Army, G&G (with some exceptions), G&P, ICS, JG, King Arms, KWA (gen 2.0, 2.5+ and 3.0+), Retro arms, Specna arms, Ultimate and VFC. Gearbox adjustments are required for Cyma, G&G G2 and Krytac gearboxes. Check the manual for exact compatibility information.

Súly: 20g